Flash-to-Pass
This feature lets you use your high-beam headlamps to signal a driver in front of you that you want to pass. It works even if your headlamps are in the automatic position.
To use it, pull the turn signal lever toward you, then release it.
If the headlamps are in the automatic position or on low beam, the high-beam headlamps turn on. They will stay on as long as you hold the lever toward you. The high-beam indicator on the instrument panel cluster comes on. Release the lever to return to normal operation.
See also:
Rear Climate Control System
The lower buttons on the rear seat audio are used
to adjust the rear seat climate controls. The
temperature of the air coming through the rear
outlets is determined by the front passenger’s
temp ...
If the Off Indicator Is Lit for an Adult-Size Occupant
If a person of adult size is sitting in the front outboard passenger seat, but
the off indicator is lit, it could be because that person is not sitting properly
in the seat. Use the following st ...
Using the Store Command
The store command allows a phone number to be
stored without entering the digits individually.
1. Press and hold for two seconds.
The system
responds with “Ready” followed by a tone.
2. S ...