Customer Information

See also:

Compass Calibration Procedure
1. Before calibrating the compass, check that the compass zone is set to the variance zone in which the vehicle is located. See “Compass Variance (Zone) Procedure” earlier in this section. ...

Voltmeter Gage
When your engine is not running, but the ignition is in RUN, this gage shows your battery’s state of charge in DC volts. When the engine is running, the gage shows the condition of the ch ...

Exterior Lighting
The exterior lamp control is located on the instrument panel on the outboard side of the steering wheel. Turn the control to the following positions: : Turns off the exterior lamps. The kn ...