StabiliTrak® System

The vehicle has a vehicle stability enhancement system called StabiliTrak. It is an advanced computer controlled system that assists with directional control of the vehicle in difficult driving conditions.

StabiliTrak activates when the computer senses a difference between the intended path, and the direction the vehicle is actually traveling. StabiliTrak selectively applies braking pressure at any one of the vehicle's brakes to help steer the vehicle in the intended direction.

StabiliTrak is on automatically whenever the vehicle is started. To assist with directional control of the vehicle, the system should always be left on.

TCS/StabiliTrak Light

TCS/StabiliTrak Light

When the stability control system activates, also occurs when traction control is activated. A noise may be heard or vibration flashes on the instrument panel. This also occurs when traction control is activated. A noise may be heard or vibration may be felt in the brake pedal. This is normal. Continue to steer the vehicle in the intended direction. If there is a problem detected with StabiliTrak, the appropriate message will be displayed on the DIC. See Ride Control System Messages .

When this message is displayed and/or d comes on and stays on, the vehicle is safe to drive but the system is not operational. Driving should be adjusted accordingly. If and stays on, reset the system: comes on and stays on, reset the system:

1. Stop the vehicle.

2. Turn the engine off and wait 15 seconds.

3. Start the engine.

If a speed above 20 km/h (13 mi/h), see your dealer for service. still comes on and stays on at a speed above 20 km/h (13 mi/h), see your dealer for service.

TCS/StabiliTrak Button

TCS/StabiliTrak Button

This button is located below the infotainment system screen.

StabiliTrak can be turned off if needed by pressing and holding g until

StabiliTrak can be turned off if needed by pressing and holding g until come on in the instrument panel and and the appropriate message displays on the DIC. When StabiliTrak is turned come on in the instrument panel and the appropriate message displays on the DIC. When StabiliTrak is turned off, the system will not assist with directional control of the vehicle or limit wheel spin. Driving should be adjusted accordingly. Press and release back on. again to turn the system back on.

If cruise control is being used when StabiliTrak activates, cruise control will automatically disengage. Press the appropriate cruise control button to reengage when road conditions allow. See Cruise Control  for more information.

    See also:

    Sensors
    The solar sensor, located on top of the instrument panel near the windshield, monitors the solar heat. The climate control system uses the sensor information to adjust the temperature, fan speed, ...

    To Transfer Audio to the In-Vehicle Bluetooth System
    The cellular phone must be paired and connected with the Bluetooth system before a call can be transferred. The connection process can take up to two minutes after the key is turned to the ON/RUN ...

    Engine Coolant Temperature Gauge
    Metric English This gauge shows the engine coolant temperature. If the indicator needle moves to the hot side of the gauge toward the shaded area, the engine is too hot. If the vehicle has been ...