Starting the Vehicle

To start the engine using the remote start feature:

1. Aim the RKE transmitter at the vehicle.
2. Press and release 3. Immediately after completing Step 2, press and hold.
3. Immediately after completing Step 2, press and hold or for about two seconds if the vehicle is not in view. until the turn signal lamps flash, or for about two seconds if the vehicle is not in view.

When the engine starts, the parking lamps will turn on and remain on as long as the engine is running. The doors will be locked and the climate control system may come on.

The engine will continue to run for 10 minutes. Repeat the steps for a 10-minute time extension. Remote start can be extended only once.

Start the vehicle before driving.

    See also:

    Checking Engine Oil
    It is a good idea to check the engine oil every time you get fuel. In order to get an accurate reading, the oil must be warm and the vehicle must be on level ground. The engine oil dipstick hand ...

    Exit Lighting
    The headlamps, taillamps, parking lamps, back-up lamps, and license plate lamps come on at night, or in areas with limited lighting, when the key is removed from the ignition. The dome lamps ...

    Roadside Assistance and OnStar
    If you have an active OnStar subscription, press the Q button and the current GPS location will be sent to an OnStar Advisor who will assess your problem, contact Roadside Assistance, and relay y ...