Taillamps, Turn Signal, Sidemarker, and Stoplamps

A. Taillamp

A. Taillamp
B. Sidemarker Lamp

To replace one of these bulbs:

1. Open the liftgate. See Liftgate .
2. Remove the black cuff from the lamp assembly by pulling rearward from the top to unfasten it from the snap tabs.
3. Remove the two hex nuts holding the taillamp assembly in place.
4. Pull out the taillamp assembly.
5. Turn the bulb socket counterclockwise and pull it straight out to remove it.
6. Replace the bulb.
7. Reverse Steps 3 through 5 to reinstall the taillamp assembly.

When reinstalling the taillamp assembly, the pin on the taillamp assembly must line up and be inserted correctly into the opening.
8. Replace the black cuff over the lamp assembly by pushing it into the snap tabs.

    See also:

    Air Vents
    Use the louvers located on the air vents to change the direction of the airflow. To open a vent, move the thumbwheel to | . To close the vent, move the thumbwheel to . Operation Tips ► Keep a ...

    Antilock Brake System (ABS)
    This vehicle has the Antilock Brake System (ABS), an advanced electronic braking system that helps prevent a braking skid. When the engine is started and the vehicle begins to drive away, ABS check ...

    Starter Switch Check
    WARNING When you are doing this inspection, the vehicle could move suddenly. If the vehicle moves, you or others could be injured. 1. Before starting this check, be sure there is enough room aroun ...