High Intensity Discharge (HID) Lighting
WARNING!
The low beam high intensity
discharge lighting system
operates at a very high voltage.
If you try to service any of the
system components, you could be
seriously injured. Have your
dealer or a qualified technician
service them.
After an HID headlamp bulb has been replaced, the beam might be a slightly different shade than it was originally. This is normal.
See also:
SBZA Detection Zones
The SBZA sensor covers a zone of approximately one
lane over from both sides of the vehicle, 3.5 m (11 ft).
This zone starts at each side mirror and goes back
approximately 5 m (16 ft). The hei ...
Using the Directory Command
The directory command lists all of the name tags stored by the system.
To use the directory command:
1. Press
.
► For vehicles without a navigation system, the system responds “Ready,” f ...
Entry Lighting
The headlamps, parking lamps, taillamps, and most of the interior lamps turn
on briefly when is pressed on the
Remote Keyless Entry (RKE) transmitter. After about 30 seconds the exterior lamps
...