Starter Switch Check

WARNING!
When you are doing this inspection, the vehicle could move suddenly. If the vehicle moves, you or others could be injured.

1. Before starting this check, be sure there is enough room around the vehicle.

2. Firmly apply both the parking brake and the regular brake.

See Parking Brake.

Do not use the accelerator pedal, and be ready to turn off the engine immediately if it starts.

3. Try to start the engine in each gear. The vehicle should start only in P (Park) or N (Neutral).

If the vehicle starts in any other position, contact your dealer for service.

    See also:

    Programming Universal HomeRemote — Rolling Code
    Rolling code garage door openers are used for garage doors produced after 1996 and are code protected. Rolling code means the coded signal is changed every time your remote control garage door ope ...

    Wiper Activated Headlamps
    This feature activates the headlamps and parking lamps after the windshield wipers are turned on and have completed eight wipe cycles within four minutes. When the ignition is turned to LOCK/OFF, ...

    Low-Beam Headlamps/Daytime Running Lamps (DRL), High-Beam Headlamps (Base)
    1. For the driver side bulb, remove the windshield washer bottle filler neck by firmly pulling it straight up and out of the bottle. 2. Remove the outside cap for the low-beam headlamp/DRL bulb repla ...