Conference Calling
Conference calling and three-way calling must be supported on the Bluetooth phone and enabled by the wireless service carrier to work.
To start a conference while in a current call:
1. Turn the Menu Knob and press SELECT.
2. Select Enter Number.
3. Enter the character sequence then select Call. See “Entering a Character Sequence” in Operation for more information.
4. After the call has been placed, turn the Menu Knob to choose Merge Calls then press SELECT.
5. To add more callers to the conference call, repeat Steps 1 through 4. The number of callers that can be added is limited by your wireless service carrier.
See also:
Introduction
GENERAL MOTORS, GM, the GM Emblem, BUICK, the
BUICK Emblem, and the name LUCERNE are
registered trademarks of General Motors Corporation.
This manual describes features that may or may not be ...
Tire Sealant and Compressor Kit
WARNING:
Idling a vehicle in an enclosed area with poor
ventilation is dangerous. Engine exhaust may
enter the vehicle. Engine exhaust contains Carbon
Monoxide (CO) which cannot be seen or smel ...
Audio Source
VOL/ (Volume/Power):
1. Press to turn the radio on or off.
2. Turn to increase or decrease the
volume of the active source
(i.e., current audio source, active
navigation voice guidance,
or ...
