Conditions in Which Remote Start Will Not Work

The remote start will not operate if:

• The key is in the ignition (key access) or the ignition is in any position other than OFF (keyless access).

• The transmitter is in the vehicle (keyless access).

• The hood is not closed.

• The hazard warning flashers are on.

• There is an emission control system malfunction.

• The engine coolant temperature is too high.

• The oil pressure is low.

• Two remote vehicle starts have already been used.

• The vehicle is not in P (Park).

    See also:

    SBZA Detection Zones
    The SBZA sensor covers a zone of approximately one lane over from both sides of the vehicle, 3.5 m (11 ft). This zone starts at each side mirror and goes back approximately 5 m (16 ft). The hei ...

    Doing Your Own Service Work
    WARNING: You can be injured and the vehicle could be damaged if you try to do service work on a vehicle without knowing enough about it. • Be sure you have sufficient knowledge, experience, ...

    Immobilizer
    See Radio Frequency Statement  for information regarding Part 15 of the Federal Communications Commission (FCC) rules and Industry Canada Standards RSS-GEN/210/220/310. ...