Extending Engine Run Time
The engine will continue to run for 10 minutes. Repeat the steps for a 10-minute time extension. Remote start can only be extended once.
When remote start is extended, the second 10 minutes will start immediately.
For example, if the vehicle has been running for five minutes, and 10 minutes are added, the engine will run for a total of 15 minutes.
A maximum of two remote starts or remote start attempts are allowed between ignition cycles.
The vehicle's ignition must be turned on and then back off before the remote start procedure can be used again.
See also:
Hydraulic Clutch
For vehicles with a manual transmission, it is not necessary to regularly check brake/clutch fluid unless there is a leak suspected.
Adding fluid will not correct a leak.
A fluid loss in this system ...
Ignition Transmission Lock Check
While parked, and with the parking
brake set, try to turn the ignition to
LOCK/OFF in each shift lever
position.
• The ignition should turn to
LOCK/OFF only when the shift
lever is in P ( ...
Unable to Connect to OnStar
Message
If there is limited cellular coverage
or the cellular network has reached
maximum capacity, this message
may come on. Push to try the
call again or try again after driving a
few miles into ...