Starting the Engine Using Remote Start

To start the engine using the remote start feature:

1. Aim the RKE transmitter at the vehicle.

2. Press and release 3. Immediately after completing.

3. Immediately after completing Step 2, press and hold the turn signal lamps flash, or for until the turn signal lamps flash, or for about two seconds if the vehicle is not in view.

When the engine starts, the parking lamps will turn on and remain on as long as the engine is running. The doors will be locked and the climate control system may come on.

Turn the ignition to ON/RUN (key access), or select the ON/RUN/START ignition position (keyless access), to drive the vehicle.

The engine will shut off after 10 minutes unless a time extension is done or the ignition is put in ON/RUN (key access) or ON/RUN/START (keyless access).

When the vehicle is started remotely, the climate control remote start. system will use the last setting before the vehicle was shut off. See “Remote Start Climate Control Operation” in Automatic Climate Control System or Dual Automatic Climate Control System. Vehicles with heated or heated and ventilated front seats can have this feature turn on automatically during a remote start.

See “Remote Start Heated Seats” and “Remote Start Cooled Seats” under Vehicle Personalization for more information.

    See also:

    All Vehicles
    WARNING! You can be injured and the vehicle could be damaged if you try to do service work on a vehicle without knowing enough about it. • Be sure you have sufficient knowledge, experience ...

    Muting a Call
    During a call, all sounds from inside the vehicle can be muted so that the person on the other end of the call cannot hear them. To Mute a call 1. Press . The system responds “Ready,” followe ...

    Managing the Vehicle Damage Repair Process
    In the event that your vehicle requires damage repairs, GM recommends that you take an active role in its repair. If you have a pre-determined repair facility of choice, take your vehicle there, ...