Starting the Vehicle

1. Aim the RKE transmitter at the vehicle.

2. Press and release 3. Immediately after completing.

3. Immediately after completing Step 2, press and hold the turn signal lamps flash, or for until the turn signal lamps flash, or for about two seconds if the vehicle is not in view.

When the engine starts, the parking lamps will turn on and remain on as long as the engine is running. The doors will be locked and the climate control system may come on.

The engine will continue to run for 10 minutes. Repeat the steps for a 10-minute time extension. Remote start can be extended only once.

    See also:

    Adjustable Throttle and Brake Pedal
    If your vehicle has this feature, you can change the position of the throttle and brake pedals. This feature is designed for shorter drivers, since the pedals cannot move farther away from the s ...

    Taillamps and Back-Up Lamps
    A. Taillamp B. Back-up Lamp To replace an auxiliary taillamp or back-up lamp bulb: 1. Open the trunk. See Trunk. 2. Remove the three fasteners from the trunk trim. 3. Pull back the trunk trim ...

    Scheduled Maintenance
    When the CHANGE ENGINE OIL DIC message comes on, it means that service is required for your vehicle. Have your vehicle serviced as soon as possible within the next 600 miles (1 000 km). It is poss ...