Low-Beam Headlamps/Daytime Running Lamps (DRL), High-Beam Headlamps (Base)

1. For the driver side bulb, remove the windshield washer bottle filler neck by firmly pulling it straight up and out of the bottle.
2. Remove the outside cap for the low-beam headlamp/DRL bulb replacement from the back of the headlamp assembly.
3. Remove the inside cap for the high-beam headlamp bulb replacement from the back of the headlamp assembly.
4. Disconnect the electrical connector.
5. Remove the bulb socket from the headlamp assembly.
6. Replace the bulb in the bulb socket.
7. Install the bulb socket in the headlamp assembly.
8. Reverse Steps 1 through 4 to reinstall the outside or inside cap on the headlamp assembly.

    See also:

    Keyless Unlocking
    With the RKE transmitter within 1m(3 ft), approach the door and pull the handle to unlock and open the door. If the transmitter is recognized, the door will unlock and open. Entering any door oth ...

    How to Add Coolant to the Surge Tank
    WARNING: You can be burned if you spill coolant on hot engine parts. Coolant contains ethylene glycol and it will burn if the engine parts are hot enough. Do not spill coolant on a hot engine. ...

    Battery
    The battery supplies power to start the engine and operate any additional electrical accessories. • To avoid break-down or failure to start the vehicle, maintain a battery with full crankin ...