Sending a Stored Name Tag During a Call

1. Press with “Ready”. The system responds with “Ready” followed by a tone.

2. Say “Send name tag.” The system responds with “Say a name tag to send tones” followed by a tone.

3. Say the name tag to send.

• If the system clearly recognizes the name tag it responds with “OK, Sending <name tag>” and the dial tones are sent and the call continues.

• If the system is not sure it recognized the name tag properly, it responds “Dial <name tag>, Please say yes or no?” followed by a tone. If the name tag is correct, say “Yes”. The system responds with “OK, Sending <name tag>” and the dial tones are sent and the call continues.

    See also:

    Warning Lights, Gages, and Indicators
    Warning lights and gages can signal that something is wrong before it becomes serious enough to cause an expensive repair or replacement. Paying attention to the warning lights and gages could p ...

    ENGINE OIL LOW — ADD OIL
    This message displays when the engine oil level is too low. Check the oil level. See Engine Oil. ...

    Calling for Assistance
    When calling Roadside Assistance, have the following information ready: • Your name, home address, and home telephone number. • Telephone number of your location. • Location of the ve ...