Sending a Number During a Call

1. Press with “Ready”. The system responds with “Ready” followed by a tone.

2. Say “Dial”. The system responds with “Say a number to send tones” followed by a tone.

3. Say the number to send.

• If the system clearly recognizes the number it responds with “OK, Sending Number” and the dial tones are sent and the call continues.

• If the system is not sure it recognized the number properly, it responds “Dial Number, Please say yes or no?” followed by a tone. If the number is correct, say “Yes”. The system responds with “OK, Sending Number” and the dial tones are sent and the call continues.

    See also:

    Tire and Loading Information Label
    A vehicle specific Tire and Loading Information label is attached to the center pillar (B-pillar). With the driver’s door open, you will find the label attached below the door lock post (st ...

    License Plate Lamp
    To replace one of these bulbs: Passenger Side Shown, Driver Side Similar 1. Push the release tab (A) toward the lamp assembly. 2. Pull the lamp assembly down to remove. A. Bulb Socket B. B ...

    Fuses and Circuit Breakers
    The wiring circuits in the vehicle are protected from short circuits by a combination of fuses and circuit breakers. This greatly reduces the chance of damage caused by electrical problems. ...