Voice Pass-Thru

Voice Pass-Thru allows access to the voice recognition commands on the cell phone. See the cell phone manufacturers user guide to see if the cell phone supports this feature. This feature can be used to verbally access contacts stored in the cell phone.

1. Press and hold The system for two seconds. The system responds with “Ready” followed by a tone.

2. Say “Bluetooth”. The system responds with “Bluetooth ready” followed by a tone.

3. Say “Voice”. The system responds with “OK, accessing <phone name>”.

• The cell phone’s normal prompt messages will go through its cycle according to the phone’s operating instructions.

    See also:

    Engine Compartment Fuse Block
    To open the fuse block cover, press the clips at the front and back and rotate the cover up to the side. Notice: Spilling liquid on any electrical component on the vehicle may damage it. Always ...

    Control Buttons(radio with CD and Radio with CD/DVD/MEM)
    The buttons used to control the radio are: RADIO/BAND: Press to turn the radio on and choose between AM, FM, and XM™, if equipped. Menu Knob: Turn to navigate the available menus. TUNE: T ...

    Sunroof
    The vehicle may be equipped with a power sliding sunroof. To open or close the sunroof, the ignition must be turned to ON, ACCESSORY, or Retained Accessory Power (RAP) must be active. Press and ...