Using the Re-dial Command
1. Press and hold 
for two
seconds. The system
responds with “Ready” followed by a tone.
2. After the tone, say “Re-dial”. The system responds with “Re-dial using <phone name>” and dials the last number called from the connected Bluetooth phone.
Once connected, the person called will be heard through the audio speakers.
See also:
Taillamps, Turn Signal, Stoplamps, and Back-Up Lamps
A. Back-Up Lamp
B. Turn Signal Lamp
To replace one of these lamps:
1. Open the trunk. See Trunk.
2. Remove the fasteners and pull
back the trunk trim.
3. Remove the four plastic wing
nuts h ...
Brake Adjustment
Every time the brakes are applied, with or without the
vehicle moving, the brakes adjust for wear. ...
If the Off Indicator is Lit for an
Adult-Size Occupant
If a person of adult-size is sitting in the right front
passenger seat, but the off indicator is lit, it could be
because that person is not sitting properly in the seat.
If this happens, use t ...