Using the Digit Dial Command
1. Press and hold for two seconds. The system responds with “Ready” followed by a tone.
2. Say “Digit Dial”. The system responds with “Digit dial using <phone name>, please say the first digit to dial” followed by a tone.
3. Say the digit to be dialed one at a time. Following each digit, the system will repeat back the digit it heard followed by a tone.
4. Continue entering digits until the number to be dialed is complete. After the whole number has been entered, say “Dial”. The system responds with “OK, Dialing” and dials the number.
• If an unwanted number is recognized by the system, say “Clear” at any time to clear the last number.
• To hear all of the numbers recognized by the system, say “Verify” at any time and the system will repeat them.
See also:
Using the Dial Command
1. Press
.
► For vehicles without a navigation system, the system responds “Ready,” followed by a tone.
► For vehicles with a navigation system, the system responds with a tone. Aft ...
Using the Directory Command
The directory command lists all of the name tags stored
by the system. To use the directory command:
1. Press and hold for two seconds.
The system
responds with “Ready” followed by a tone. ...
Radio with CD (MP3)
If your vehicle has the Bose® audio system, your
vehicle has six Bose® amplified speakers. ...