Using the Directory Command

The directory command lists all of the name tags stored by the system. To use the directory command:

1. Press and hold The system for two seconds. The system responds with “Ready” followed by a tone.

2. Say “Directory”. The system responds with “Directory” and then plays back all of the stored name tags. When the list is complete, the system returns to the main menu.

    See also:

    Driving on Wet Roads
    Rain and wet roads can reduce vehicle traction and affect your ability to stop and accelerate. Always drive slower in these types of driving conditions and avoid driving through large puddles and ...

    Hazard Warning Flashers
    Hazard Warning Flasher: Press this button located on the instrument panel above the audio system, to make the front and rear turn signal lamps flash on and off. Press again to turn the flashe ...

    Rear Door Security Locks
    Rear door security locks prevent passengers from opening the rear doors from the inside. The rear door security locks are located on the inside edge of each rear door. The rear doors must be ...