Using the Digit Dial Command
1. Press .
► For vehicles without a navigation system, the system responds “Ready,” followed by a tone. ► For vehicles with a navigation system, the system responds with a tone. After the tone, say “Hands Free.” The system responds “Ready,” followed by a tone.2. Say “Digit Dial.” The system responds “Digit dial using <phone name>, please say the first digit to dial,” followed by a tone.
3. Say the digits to be dialed one at a time. The system repeats back the digit it heard followed by a tone.
4. Continue entering digits until the number to be dialed is complete.
After the entire number has been entered, say “Dial.” The system responds “OK, Dialing” and dials the number.
► If an unwanted number is recognized by the system, say “Clear” at any time to clear the last number. ► To hear all of the numbers recognized by the system, say “Verify” at any time.See also:
Sending a Stored Name Tag During a Call
1. Press . The system responds
with “Ready”
followed by a tone.
2. Say “Send name tag.” The system responds with
“Say a name tag to send tones” followed by a tone.
3. Say the name ...
Traction Control System (TCS)
Warning Light
For vehicles with a
Traction Control System
(TCS) and StabiliTrak®
warning light, this
light comes on briefly
when the engine is started.
If it does not, have the vehicle serviced by you ...
High/Low-Beam Headlamps (Up-Level)
The high/low-beam headlamps on the up-level headlamp system are High Intensity Discharge (HID) and should be replaced at the dealer. ...