Using the Digit Store Command
The digit store command allows a phone number to be stored by entering the digits individually.
1. Press
.
2. Say “Digit Store.” The system responds with “Please say the first digit to store,” followed by a tone.
3. Say the first digit to be stored.
The system will repeat back the digit it heard followed by a tone.
Continue entering digits until the number to be stored is complete.
► If an unwanted number is recognized by the system, say “Clear” at any time to clear the last number. ► To hear all of the numbers recognized by the system, say “Verify” at any time.4. After the complete number has been entered, say “Store.” The system responds “Please say the name tag,” followed by a tone.
5. Say a name tag for the phone number. The name tag is recorded and the system responds “About to store <name tag>. Does that sound OK?” . If the name tag does not sound correct, say “No” and repeat Step 5.
► If the name tag sounds correct, say “Yes” and the name tag is stored. After the number is stored, the system returns to the main menu.See also:
Turn Signals When Towing a Trailer
The arrows on the instrument panel flash whenever signaling a
turn or lane change. Properly hooked up, the trailer lamps also flash, telling other
drivers the vehicle is turning, changing lanes, o ...
Reading Lamps
The reading lamps are located in the headliner.
or
: Press the button near each lamp to
turn it on or off. ...
Windshield Wiper/Washer
The windshield wiper lever is located on the left side of
the steering column.
: Use for a single wiping cycle.
: Delays wiping cycle.
: Slow wipes.
: Fast wipes.
: Turns the wiper ...
