Erasing Universal Home Remote Buttons

The programmed buttons should be erased when the vehicle is sold or the lease ends.

To erase either Rolling Code or Fixed Code on the Universal Home Remote device:

1. Press and hold the two outside buttons at the same time for approximately 20 seconds, until the indicator lights, located directly above the buttons, begin to blink rapidly.

2. Once the indicator lights begin to blink, release both buttons. The codes from all buttons will be erased.

For help or information on the Universal Home Remote System, call the customer assistance phone number under Customer Assistance Offices.

    See also:

    Exterior Lamp Controls
    Exterior Lamp Controls The exterior lamp control is located on the instrument panel on the outboard side of the steering wheel. Turn the control to the following positions: (Off): Turns of ...

    How to Detect a Tamper Condition
    If is pressed and the horn sounds, an attempted break-in occurred while the system was armed. If the alarm has been activated, a message will appear on the DIC. See Anti-theft Alarm System Messa ...

    Certification/Tire Label
    A vehicle specific Certification/Tire label is found on the rear edge of the driver’s door. The label shows the size of your vehicle’s original tires and the inflation pressures needed to obt ...