When the System Does Not Seem to Work Properly
If the URPA system will not activate due to a temporary condition, the message PARK ASSIST OFF will be displayed on the DIC and a red light will be shown on the rear URPA display when the shift lever is moved into R (Reverse). This occurs under the following conditions:
• The driver disables the system.
• The ultrasonic sensors are not clean. Keep the vehicle’s rear bumper free of mud, dirt, snow, ice and slush. For cleaning instructions, see Washing Your Vehicle.
• A trailer was attached to the vehicle, or a bicycle or an object was hanging out of the trunk during the last drive cycle, the red light may illuminate in the rear display. Once the attached object is removed, URPA will return to normal operation.
• A tow bar is attached to the vehicle.
• The vehicle’s bumper is damaged. Take the vehicle to your dealer/retailer to repair the system.
• Other conditions may affect system performance, such as vibrations from a jackhammer or the compression of air brakes on a very large truck.
If the system is still disabled after driving forward at least 25 km/h (15 mph), take the vehicle to your dealer/retailer.
See also:
Safety Warnings and Symbols
Warning Messages found on vehicle labels and in this
manual describe hazards and what to do to avoid
or reduce them.
Danger indicates a hazard with a high level of risk
which will result in ser ...
Manual Operation
(Off): Turns the climate
control system off. Outside
air still enters the vehicle and is directed to the floor.
The airflow direction and temperature can be adjusted.
If the temperature is adju ...
Six-Disc CD (MP3) Player
To set the time and date:
1. Turn the ignition key to ACC/ACCESSORY or
ON/RUN. Press to turn the radio
on.
2. Press MENU.
3. Press the softkey below the
tab. The HR, MIN,
MM, DD, YYYY dis ...