License Plate Lamp

To replace one of these bulbs, do the following:

1. Remove the two screws holding the license plate lamp lens.

2. Pull the lens away from the lamp assembly.

2. Pull the lens away from the lamp assembly.
3. Pull the old bulb from the bulb socket, keeping the bulb straight as you pull it out.
4. Install the new bulb.
5. Replace the lamp assembly lens and tighten the screws.

    See also:

    Weatherstrips
    Apply silicone grease on weatherstrips to make them last longer, seal better, and not stick or squeak. See Recommended Fluids and Lubricants . ...

    Safety
    In Insurance Institute for Highway Safety crash tests, the Lucerne rates Good, the best possible score, in the frontal-offset test and Acceptable in the side impact. Acceptable is, well, acceptabl ...

    Retained Accessory Power (RAP)
    These vehicle accessories can be used for up to 10 minutes after the engine is turned off: • Audio System • Power Windows • Sunroof (If Equipped) • Auxiliary Power Outlet Power to the ...