Battery Replacement

To change the batteries, do the following:

1. Remove the battery compartment door located on the bottom of the remote control.
2. Replace the two AA batteries in the compartment. Make sure that they are installed correctly, using the diagram on the inside of the battery compartment.
3. Close the battery door securely.

If the remote control is to be stored for a long period of time, remove the batteries and keep them in a cool, dry place.

DVD Messages

    See also:

    Hazard Warning Flashers
    Hazard Warning Flashers Hazard Warning Flasher: Press this button to make the front and rear turn signal lamps flash on and off. Press again to turn the flashers off. The hazard warning fl ...

    Reporting Safety Defects to the United States Government
    If you believe that your vehicle has a defect which could cause a crash or could cause injury or death, you should immediately inform the National Highway Traffic Safety Administration (NH ...

    Voltmeter Gage
    When your engine is not running, but the ignition is in RUN, this gage shows your battery’s state of charge in DC volts. When the engine is running, the gage shows the condition of the ch ...