Stopping and Resuming Playback

To stop playing a disc, press and release the stop button on the DVD player faceplate or the remote control.

To resume playback, press the play/pause button on the DVD player faceplate or the remote control. The movie should resume play from where it was last stopped, if the disc has not been ejected and the stop button has not been pressed twice. If the disc has been ejected or if the stop button has been pressed twice, the disc will resume play at the beginning.

    See also:

    Adjusting the Speakers (Balance/Fade)
    BAL/FADE (Balance/Fade): To adjust balance or fade, press the if the radio has this symbol, or the knob until the speaker control tabs display. Continue pressing to highlight the desire ...

    Driver Information Center (DIC)
    The DIC display is located in the center of the instrument panel cluster. It shows the status of many vehicle systems. The controls for the DIC are located on the turn signal lever. A. SE ...

    Removing and Replacing the Floor Mats
    Pull up on the rear of the floor mat to unlock each retainer and remove. Reinstall by lining up the floor mat retainer openings over the carpet retainers and snap into position. Make sure the fl ...