Setting Preset PTYs (RDS Only)

These pushbuttons have factory PTY presets.

Up to 12 PTYs (six FM1 and six FM2), can be programmed on the six numbered pushbuttons, by performing the following steps:

1. Press BAND to select FM1 or FM2.
2. Press the TYPE button to activate program type select mode. P-TYPE and the last selected PTY displays.
3. Turn the TYPE knob or press and release the TYPE button to select a PTY.
4. Press and hold one of the six numbered pushbuttons until a beep sounds. When that numbered pushbutton is pressed (while in PTY mode), the PTY that was set, returns.
5. Repeat the steps for each pushbutton.

    See also:

    Exterior Lamp Controls
    Exterior Lamp Controls The exterior lamp control is located on the instrument panel on the outboard side of the steering wheel. Turn the control to the following positions: (Off): Turns of ...

    Front Fog Lamp Light
    For vehicles with fog lamps, this light comes on when the fog lamps are in use. The light goes out when the fog lamps are turned off. See Fog Lamps  for more information. ...

    Interior Lighting
    Dome Lamps The interior lamps control located in the overhead console controls both the front and rear interior lamps. : Turns the lamps off. : Turns the lamps on when any door is opened. : Keeps ...