Finding a Station

BAND: Press this button to switch between FM1, FM2, AM, or XM1 or XM2 (if equipped). The display shows the selection.

TUNE: Turn this knob to select radio stations.

: Press either the SEEK or the SEEK TYPE: Press either the SEEK or the TYPE arrows to go to the next or to the previous station and stay there.

The radio only seeks stations with a strong signal that are in the selected band.

: Press and hold either the SCAN SCAN or: Press and hold either the SCAN or the TYPE arrows for two seconds until SCAN displays and a beep sounds. The radio goes to a station, plays for a few seconds, then goes to the next station. Press either the SCAN or the TYPE arrows again to stop scanning.

To scan preset stations, press and hold either the SCAN or the TYPE arrows for more than four seconds. PSCN displays and a double beep sounds. The radio goes to a preset station, plays for a few seconds, then goes to the next preset station. Press either the SCAN or the TYPE arrows again to stop scanning presets.

The radio only scans stations with a strong signal that are in the selected band.

    See also:

    Object Detection System Messages
    PARK ASSIST OFF This message is displayed when the park assist system has been turned off. See Ultrasonic Parking Assist . SERVICE PARK ASSIST This message is displayed if there is a problem with ...

    Tire Pressure Monitor System
    The Tire Pressure Monitor System (TPMS) uses radio and sensor technology to check tire pressure levels. The TPMS sensors monitor the air pressure in your vehicle’s tires and transmit tire pres ...

    Right Front Passenger Position
    To learn how to wear the right front passenger’s safety belt properly, see Driver Position on page 24. The right front passenger’s safety belt works the same way as the driver’s safety bel ...