Setting the Time
The radio may have a button marked with an H or HR to represent hours and an M or MN to represent minutes.
Press and hold the hour button until the correct hour appears on the display. AM or PM will appear on the display for morning or evening hours.
Press and hold the minute button until the correct minute appears on the display. The time can be set with the ignition on or off.
To synchronize the time with an FM station broadcasting Radio Data System (RDS) information, press and hold the hour and minute buttons at the same time until UPDATED and the clock symbol appear on the display. If the time is not available from the station, NO UPDAT will appear on the display.
RDS time is broadcast once a minute. After tuning to an RDS broadcast station, it may take a few minutes for the time to update.
See also:
Power Tilt Wheel and Telescopic
Steering Column
For vehicles with a power
tilt control, it is located on
the left hand side of
the steering column.
To adjust the power tilt wheel:
• Push the control up or down to tilt the steering
whe ...
Making a Call
Calls can be made using the following commands.
Dial or Call: The dial or call command can be used interchangeably to dial a
phone number or a stored name tag.
Digit Dial: This command allows a ph ...
Using the Directory Command
The directory command lists all of the name tags stored by the system.
To use the directory command:
1. Press
.
► For vehicles without a navigation system, the system responds “Ready,” f ...
