DIC Vehicle Customization
Your vehicle may have customization capabilities that allow you to program some features to one setting based on your preference. All of the customizable options listed may not be available on your vehicle. Only the options available display on the Driver Information Center (DIC
The default settings for the customization features were set when your vehicle left the factory, but may have been changed from their default state since then.
To change feature preferences, make sure the ignition is on and the vehicle is in PARK (P). To avoid excessive drain on the battery, it is recommended that the headlamps are turned off.
Press the customization button to scroll through the available customizable options.
After pressing the customization button, VEHICLE SETTINGS momentarily displays before going to a customization option.
See also:
Compass Calibration Procedure
1. Before calibrating the compass, check that the
compass zone is set to the variance zone in
which the vehicle is located. See “Compass
Variance (Zone) Procedure” earlier in this section.
...
Removing the Spare Tire and Tools
To access the spare tire and tools:
1. Open the trunk. See Trunk .
2. Lift the load floor.
A. Retainer Nut
B. Tool Bag Tether
C. Tool Bag
D. Spare Tire
3. Turn the retainer nut (A) counter ...
Using the Dial Command
1. Press
.
► For vehicles without a navigation system, the system responds “Ready,” followed by a tone.
► For vehicles with a navigation system, the system responds with a tone. Aft ...
