Outside Air Temperature Display
A new outside temperature reading will be displayed if the vehicle has been off for more than three hours. If the vehicle has been off for less than three hours, the old temperature reading may be displayed because underhood heat is affecting the true outside temperature.
Since underhood heat can also affect the outside temperature while the engine is running, it may take several minutes of driving before the display updates to the actual outside temperature.
(Off): Press this button
to turn off the entire
climate control system. Outside air will still
enter the vehicle, and will be directed to the floor.
Press the AUTO button, the mode button, the fan arrows, or either temperature knob to turn the system on.
(Mode): Press this button to
manually select
the air delivery mode to the floor, instrument panel,
or windshield outlets. The system will stay in the
selected mode until the mode button is pressed
again or the AUTO button is pressed.
Driver’s Side Temperature Knob: Turn this knob clockwise or counterclockwise to manually raise or lower the temperature on the driver’s side of the vehicle. The display will show the temperature setting decreasing or increasing and an arrow pointing toward the driver. This knob can also adjust the passenger’s side temperature setting simultaneously if the two zones are linked as described in Passenger’s Side Temperature Knob.
Passenger’s Side Temperature Knob: Turn this knob clockwise or counterclockwise to manually raise or lower the temperature on the passenger’s side of the vehicle. The display will show the temperature setting decreasing or increasing and an arrow pointing toward the passenger. The passenger’s temperature setting can be set to match and link to the driver’s temperature setting by pressing and holding the AUTO button for three seconds. Now, by adjusting the driver’s side temperature setting, the passenger’s side temperature setting will follow and both arrows will appear on the display. The passenger’s side temperature setting also resets and relinks to the driver’s side temperature setting if the vehicle has been off for more than three hours.
See also:
Using the Tire Sealant and Compressor
Kit without Sealant to Inflate a Tire
(Not Punctured)
To use the air compressor to inflate a tire with air only
and not sealant:
Always do a safety check first. See If a Tire Goes Flat .
1. Remove the tire sealant and compressor kit from its
stor ...
Transmission
Automatic Transmission
P: Park
R: Reverse
N: Neutral
D: Drive
Manual Mode
Move the selector lever from D (Drive) to the left. Press the shift lever forward (+) to upshift or rearward ( ...
Starting the Vehicle
1. Aim the RKE transmitter at the vehicle.
2. Press
.
3. Immediately after completing Step 2, press and
hold until the turn signal lamps
flash.
When the vehicle starts, the parking lamps w ...
