Flash-to-Pass

This feature lets you use your high-beam headlamps to signal a driver in front of you that you want to pass. It works even if your headlamps are in the automatic position.

To use it, pull the turn signal lever toward you, then release it.

If the headlamps are in the automatic position or on low beam, the high-beam headlamps turn on. They will stay on as long as you hold the lever toward you. The high-beam indicator on the instrument panel cluster comes on. Release the lever to return to normal operation.

    See also:

    Safety Belts
    Refer to the following sections for important information on how to use safety belts properly. ► Safety Belts . ► How to Wear Safety Belts Properly . ► Lap-Shoulder Belt . ` ...

    Radio Messages
    CAL ERR (Calibration Error): The audio system has been calibrated for your vehicle from the factory. If CAL ERR displays, it means that the radio has not been configured properly for the vehicle a ...

    Using the Store Command
    The store command allows a phone number to be stored without entering the digits individually. 1. Press . ► For vehicles without a navigation system, the system responds “Ready,” followed ...