Reprogramming a Single UniversalHome Remote Button

To program a device to Universal Home Remote using a Universal Home Remote button previously trained, follow these steps:

1. Press and hold the desired Universal Home Remote button. Do not release the button.
2. The indicator light will begin to flash after 20 seconds. While still holding the Universal Home Remote button, proceed with Step 2 under “Programming Universal Home Remote” shown earlier in this section.

    See also:

    Windshield Washer
    (Windshield Washer): To spray washer fluid on the windshield, press the windshield washer paddle. The wipers will clear the window and then either stop or return to your preset speed. CAUTION: ...

    Introduction
    Notice: Maintenance intervals, checks, inspections, recommended fluids, and lubricants are necessary to keep this vehicle in good working condition. Damage caused by failure to follow scheduled ...

    Starting the Vehicle
    1. Aim the RKE transmitter at the vehicle. 2. Press . 3. Immediately after completing Step 2, press and hold until the turn signal lamps flash. When the vehicle starts, the parking lamps w ...