Gate Operator and CanadianProgramming

Canadian radio-frequency laws require transmitter signals to time out or quit after several seconds of transmission. This may not be long enough for Universal Home Remote to pick up the signal during programming. Similarly, some U.S. gate operators are manufactured to time out in the same manner.

If you live in Canada, or you are having difficulty programming a gate operator or garage door opener by using the “Programming Universal Home Remote” procedures, regardless of where you live, replace Step 3 under “Programming Universal Home Remote” with the following:

Continue to press and hold the Universal Home Remote button while you press and release every two seconds (cycle) the hand-held transmitter button until the frequency signal has been successfully accepted by the Universal Home Remote. The Universal Home Remote indicator light will flash slowly at first and then rapidly.

Proceed with Step 4 under “Programming Universal Home Remote” to complete.

    See also:

    Disarming the System
    To disarm the system, do one of the following: • Press on the RKE transmitter. • Approach the vehicle with the RKE transmitter (keyless access). • Start the engine. The alarm automati ...

    Sewn-in Safety Belt Comfort Guide
    On vehicles with the sewn-in comfort guide, there is one guide for each outboard passenger position in the rear seat. To install a comfort guide to the safety belt: 1. Remove the guide from its st ...

    Steering Wheel Adjustment
    Steering Wheel Adjustment To adjust the steering wheel: 1. Pull the lever (A) down. 2. Move the steering wheel up or down. 3. Pull or push the steering wheel closer or away from you. 4. Pul ...