Erasing Universal Home RemoteButtons
You should erase the programmed buttons when you sell the vehicle or terminate your lease.
To erase either rolling code or fixed code on the Universal Home Remote device, do the following:
1. Press and hold the two outside buttons at
the same time for approximately 20 seconds,
until the indicator lights, located directly
above the buttons, begin to blink rapidly.
2. Once the indicator lights begin to blink,
release both buttons. The codes from all
button will be erased.
For additional information on Universal Home Remote.
See also:
Sheet Metal Damage
If the vehicle is damaged and requires sheet metal
repair or replacement, make sure the body repair shop
applies anti-corrosion material to parts repaired or
replaced to restore corrosion protec ...
Object Detection System Messages
PARK ASSIST OFF
This message is displayed when the park assist system has been turned off. See Ultrasonic Parking Assist
.
SERVICE PARK ASSIST
This message is displayed if there is a problem with ...
FM
FM signals only reach about
16 to 65 km (10 to 40 mi). Although
the radio has a built-in electronic
circuit that automatically works to
reduce interference, some static can
occur, especially ...