Battery Replacement
Under normal use, the battery in your remote keyless entry transmitter should last about two years.
You can tell the battery is weak if the transmitter won’t work at the normal range in any location.
If you have to get close to your vehicle before the transmitter works, it’s probably time to change the battery.
The Driver Information Center (DIC) will display a KEY FOB # BATTERY LOW message when the transmitter battery is low.
Notice: When replacing the battery, use care not to touch any of the circuitry. Static from your body transferred to these surfaces may damage the transmitter.
To replace the battery in the remote keyless entry transmitter do the following:
1. Insert a thin coin in the slot between the
covers of the transmitter housing. Gently
pry the transmitter apart.
2. Remove and replace the battery with a
three-volt CR2032 or equivalent battery.
3. Align the covers and snap them together.
4. Check the operation of the transmitter.
See also:
Reprogramming Universal HomeRemote Buttons
You can reprogram any of the three buttons by
repeating the instructions. ...
Introduction
The names, logos, emblems, slogans, vehicle model names, and vehicle body designs appearing in this manual including, but not limited to, GM, the GM logo, BUICK, the BUICK Emblem, and REGAL are trad ...
Object Detection System Messages
PARK ASSIST OFF
This message displays when the
park assist system has been turned
off or when there is a temporary
condition causing the system to be
disabled. See Ultrasonic Parking
Assist ...