Stoplamp,Taillamp, and Turn Signal Lamp

Driver Side Shown, Passenger Side Similar

Driver Side Shown, Passenger Side Similar

A. Taillamp

B. Turn Signal Lamp

C. Stoplamp/Taillamp

To replace any one of these bulbs:

1. Open the trunk.

2. Remove the push pins securing the trunk trim.

3. Pull the trunk lining away from the taillamp assembly.

4. Turn the bulb socket counterclockwise to remove it from the rear taillamp assembly.

5. Pull the bulb straight out to remove it from the bulb socket.

6. Push the new bulb into the socket.

7. Push the bulb socket straight in and turn it clockwise to lock it into place.

8. Reinstall the trunk trim.

9. Reinstall the push pins.

    See also:

    Ending Cruise Control
    There are three ways to end cruise control: • Step lightly on the brake pedal. • Press the button on the steering wheel. • Press the button on the steering wheel. ...

    The Inside
    Where it counts, the Verano's interior feels plush — somewhere between a compact and a luxury car, but closer to the latter. Similar money could get a well-equipped Cruze or Mazda3. The Buick is ...

    ENGINE OVERHEATED — IDLE ENGINE
    This message displays when the engine coolant temperature is too hot. Stop and allow the vehicle to idle until it cools down. ...