Trunk Deck Inboard Taillamp and Backup Lamp

Driver Side Shown, Passenger Side Similar

Driver Side Shown, Passenger Side Similar

A. Backup Lamp

B. Taillamp

To replace any one of these bulbs:

1. Open the trunk.

2. Remove the push pins (A) retaining the trunk deck trim cover.

2. Remove the push pins (A) retaining the trunk deck trim cover.

3. Rotate the hinge cover (C) rearward.

4. For the passenger side bulb, remove the pull handle fasteners (B) and pull handle.

5. Pull the trunk deck trim down far enough to gain access to the lamps.

6. Remove the bulb socket by turning counterclockwise.

7. Remove the bulb from the socket by pulling straight out.

8. Install the new bulb in the bulb socket.

9. Reverse Steps 1 through 7 to reinstall.

    See also:

    Safety System Check
    Now and then, check that the safety belt reminder light, safety belts, buckles, latch plates, retractors, and anchorages are all working properly. Look for any other loose or damaged safety belt s ...

    Engine Oil Additives
    Do not add anything to the oil. The recommended oils with the starburst symbol that meet GM Standard GM6094M are all you will need for good performance and engine protection. ...

    Canceling a Remote Start
    To cancel a remote start: • Aim the RKE transmitter at the vehicle and press and hold until the parking lamps turn off. • Turn on the hazard warning flashers. • Turn the ignition switch ...