Parking/Turn Signal Lamp

1. Open the hood. See Hood .

2. Remove the parking/turn signal lamp bulb socket from the headlamp assembly by turning counterclockwise.

3. Remove the bulb from the bulb socket by pulling it straight out.

4. Install the new bulb in the bulb socket.

5. Install the bulb socket into the headlamp assembly by turning clockwise.

    See also:

    Reporting Safety Defects to the United States Government
    If you believe that your vehicle has a defect which could cause a crash or could cause injury or death, you should immediately inform the National Highway Traffic Safety Administration (NHTSA) in addi ...

    Power Reclining Seatbacks
    Driver’s Seat with Power Seat Control, Power Recline, and Power Lumbar shown If the seats have power reclining seatbacks, the controls used to operate them are located on the outboard side ...

    Traction Control System (TCS)
    The traction control system limits wheel spin. The system turns on automatically every time the vehicle is started. • To turn off traction control, press and release the Traction Control ...