Hood
To open the hood:
1. Pull up on the hood release handle. It is located inside the vehicle to the left of the steering column.
2. Go to the front of the vehicle and with hand palm side down, slide the secondary hood release handle toward the driver side of the vehicle.
3. Lift the hood and pull the prop rod by the sleeve from the retainer, located above the radiator.
4. Securely place the hood prop into the slot on the underside of the hood.
To close the hood:
1. Before closing the hood, be sure all the filler caps are on properly. Then, lift the hood to relieve pressure on the hood prop. Remove the hood prop from the slot on the underside of the hood and return the prop to its retainer. The prop rod must click into place when returning it to the retainer to prevent hood damage.
2. Lower the hood 20 cm (8 in) above the vehicle and release it so it fully latches. Check to make sure the hood is closed and repeat the process if necessary.
See also:
Cupholders
There are cupholders located in the full floor console,
or in the front of the center seat console. Cupholders are
also located in the rear armrest. Slide the cover back
to access the full floor ...
How Does an Airbag Restrain?
In moderate to severe frontal or near frontal collisions, even belted occupants can contact the steering wheel or the instrument panel. In moderate to severe side collisions, even belted occupants can ...
Safety Belt
Refer to the following sections for important information
on how to use safety belts properly.
• Safety Belts: They Are for Everyone.
• How to Wear Safety Belts Properly.
• Lap-Shoulder B ...