Manual Mode

Driver Shift Control (DSC)

Driver Shift Control (DSC), could damage the vehicle. Always upshift when necessaryNotice: Driving with the engine at a high rpm without upshifting while using Driver Shift Control (DSC), could damage the vehicle. Always upshift when necessary while using DSC.

Driver Shift Control (DSC) allows you to shift an automatic transmission similar to a manual transmission. To use the DSC feature:

1. Move the shift lever from D (Drive) to the left into the (+) or (−) manual

1. Move the shift lever from D (Drive) to the left into the (+) or (−) manual position.

2. Press the shift lever forward (+) to upshift or rearward (−) to downshift.

2. Press the shift lever forward (+) to upshift or rearward (−) to downshift. An M and the current gear will be displayed in the DIC.

While using the DSC feature, the vehicle will have firmer, quicker shifting. You can use this for sport driving or when climbing or descending hills, to stay in gear longer, or to downshift for more power or engine braking.

The transmission will only allow you to shift into gears appropriate for the vehicle speed and engine revolutions per minute (rpm).

The transmission will not automatically shift to the next lower gear if the engine rpm is too high, nor to the next higher gear when the maximum engine rpm is reached.

If shifting is prevented for any reason, the currently selected gear will flash multiple times, indicating that the transmission has not shifted gears.

While in the DSC mode, the transmission will automatically downshift when the vehicle comes to a stop. This will allow for more power during take-off.

When accelerating the vehicle from a stop in snowy and icy conditions, you may want to shift into second gear. A higher gear allows the vehicle to gain more traction on slippery surfaces.

    See also:

    Anti-theft Alarm System Messages
    THEFT ATTEMPTED This message displays if the vehicle detects a tamper condition. ...

    Convenience Net
    Use the convenience net, located in the rear, to store small loads as far forward as possible. The net should not be used to store heavy loads. ...

    Setting the Time and Date (With Date Display)
    1. Press the CONFIG button and select Time and Date Settings, or press . 2. Select Set Time or Set Date. 3. Turn the Menu knob to adjust the highlighted value. 4. Press SELECT to select the n ...