Voice Recognition

The voice recognition system uses commands to control the system and dial phone numbers.

Noise: The system may not recognize voice commands if there is too much background noise.

When to Speak: A tone sounds to indicate that the system is ready for a voice command. Wait for the tone and then speak.

How to Speak: Speak clearly in a calm and natural voice.

Audio System

When using the Bluetooth system, sound comes through the vehicle's front audio system speakers and overrides the audio system. Use the the volume level. The adjusted volume level remains in memory for later calls. The /VOL knob during a call to change the volume level. The adjusted volume level remains in memory for later calls. The system maintains a minimum volume level.

Other Information

The Bluetooth® word mark and logos are owned by the Bluetooth® SIG, Inc. and any use of such marks by General Motors is under license. Other trademarks and trade names are those of their respective owners.

See Radio Frequency Statement  for information regarding Part 15 of the Federal Communications Commission (FCC) rules and Industry Canada Standards RSS-GEN/210/220/310.

    See also:

    To Use the Engine Coolant Heater
    1. Turn off the engine. 2. Open the hood and unwrap the electrical cord. 3.6L V6 Engine The electrical cord is located on the driver side of the engine compartment, between the fender and ...

    If the Light Is On Steady
    You may be able to correct the emission system malfunction by considering the following: Did you recently put fuel into your vehicle? If so, reinstall the fuel cap, making sure to fully install ...

    Ignition Positions (Key Access)
    Ignition Positions (Key Access) The ignition switch has four different positions. Notice: Using a tool to force the key to turn in the ignition could cause damage to the switch or break t ...