Extending Engine Run Time
For a 10-minute extension, repeat Steps 1–3 while the engine is still running. The remote start can be extended once.
When the remote start is extended, the second 10 minutes will start immediately.
For example, if the engine has been running for five minutes, and 10 minutes are added, the engine will run for a total of 15 minutes.
A maximum of two remote starts, or a single start with an extension, is allowed between ignition cycles.
The vehicle's ignition must be turned on and then back off before the remote start procedure can be used again.
See also:
Dual Tone Multi-Frequency
(DTMF) Tones
The in-vehicle Bluetooth system can
send numbers during a call. This is
used when calling a menu-driven
phone system.
1. Turn the Menu knob to select
Enter Number, then press
SELECT.
2. En ...
Using the Delete Command
The delete command allows specific name tags to be
deleted.
To use the delete command:
1. Press and hold for two seconds.
The system
responds with “Ready” followed by a tone.
2. Say “D ...
Turn and Lane-Change Signals
Move the lever all the way up or down to signal a turn.
An arrow on the instrument panel cluster flashes in the direction of the turn or lane change.
Raise or lower the lever until the arrow sta ...