Base Headlamp Assembly
The base model vehicle has a halogen high-beam headlamp, a low-beam/Daytime Running Lamp (DRL) headlamp, and a turn signal/parking lamp on the headlamp assembly.
For replacement of the turn signal/parking lamp bulb on an eAssist vehicle, contact your dealer.
To replace one of these bulbs:
1. Open the hood. See Hood.
A. Low-Beam Headlamp/DRL
B. High-Beam Headlamp
C. Parking/Turn Signal Lamp
2. If replacing a headlamp bulb, remove the dust cover from the back of the headlamp housing by turning counterclockwise one-quarter turn.
3. If replacing a turn signal/parking lamp bulb on a non-eAssist vehicle, remove the close out panel push pins and close out panel covering the bulb socket.
4. Remove the bulb socket from the headlamp by turning counterclockwise one-quarter turn.
5. Remove the bulb from the socket. If replacing the high/low-beam bulb, pry the two clips on either end of the bulb and pull straight out.
6. Install the new bulb in the socket.
7. Install the bulb socket by turning clockwise one-quarter turn.
8. If a headlamp bulb was replaced, install the dust cover in the back of the headlamp housing by turning clockwise one-quarter turn.
See also:
Radio Data System (RDS)
The audio system has a Radio Data
System (RDS). RDS features are available
for use only on FM stations that broadcast
RDS information.
With RDS, the radio can do the following:
• Seek to st ...
Defensive Driving
Defensive driving means “always expect the unexpected.” The first step in driving defensively is to wear the safety belt. See Safety Belts
.
WARNING
Assume that other road users (pedestrian ...
Radio(s)
VOL/ : Press to turn the system
on and off. Turn to increase or
decrease the volume.
RADIO/BAND or SOURCE: Press
to choose between FM, AM,
or XM™, if equipped.
Menu Knob: Turn to select r ...