When the System Does Not Seem to Work Properly

The RVC system may not work properly or display a clear image if:

• The RVC is turned off. See “Turning the Rear Camera System On or Off” earlier in this section.

• It is dark.

• The sun or the beam of headlamps are shining directly into the camera lens.

• Ice, snow, mud, or anything else builds up on the camera lens.

Clean the lens, rinse it with water, and wipe it with a soft cloth.

• The back of the vehicle is in an accident. The position and mounting angle of the camera can change or the camera can be affected. Be sure to have the camera and its position and mounting angle checked at your dealer.

    See also:

    Taillamps, Turn Signal, Stoplamps, and Back-Up Lamps
    A. Back-Up Lamp B. Turn Signal Lamp To replace one of these lamps: 1. Open the trunk. See Trunk. 2. Remove the fasteners and pull back the trunk trim. 3. Remove the four plastic wing nuts h ...

    All Vehicles
    WARNING! You can be injured and the vehicle could be damaged if you try to do service work on a vehicle without knowing enough about it. • Be sure you have sufficient knowledge, experience ...

    Electric Parking Brake Light
    For vehicles with the Electric Parking Brake (EPB), the parking brake status light comes on when the parking brake is applied. If the light continues flashing after the parking brake is re ...