UHP Controls

Use the buttons located on the infotainment system and the steering wheel to operate the UHP system.

Steering Wheel Controls

Steering wheel controls can be used to:
• Answer incoming calls
• Confirm system information
• Start voice recognition
• End a call
• Reject a call
• Cancel an operation
• Make outgoing calls using the call list

answer incoming calls, to confirm (Push To Talk) : Press to answer incoming calls, to confirm system information, and to start voice control. Press and hold for two to three seconds to access the call list.

end a call, reject a call, or to cancel (End call/Mute) : Press to end a call, reject a call, or to cancel an operation.

To make outgoing calls using the call list.

1. Press the 2. Highlight the phone number by button.

2. Highlight the phone number by toggling the SRC switch up or down.

3. Dial the highlighted number by pressing the Infotainment System Controls button.

Infotainment System Controls

For information about how to navigate the menu system using the navigation system controls, see the separate Navigation System Manual.

PHONE : Press to enter the Phone main menu.

Voice Control

The voice control system uses commands to control the system and dial phone numbers.

Noise: The system may not recognize voice commands if there is too much background noise.

When to Speak: A tone sounds to indicate that the system is ready for a voice command. Wait for the tone and then speak.

How to Speak: Speak clearly in a calm and natural voice.

Audio System

When using the UHP system, sound comes through the vehicle's front audio system speakers and overrides the audio system. Use the VOL/ O knob during a call to change the volume level. The adjusted volume level remains in memory for later calls. The system maintains a minimum volume level.

Turning Bluetooth On or Off

1. Press the CONFIG button.

2. Select Phone Settings, or touch Phone on a navigation radio.

3. Select Bluetooth.

4. Select Activation.

Changing Bluetooth Code

The default Bluetooth code should work with most mobile phones.

If you are having difficulty pairing your mobile phone, you can change the code at any time.

1. Press the CONFIG button.

2. Select Phone Settings, or touch Phone on a navigation radio.

3. Select Bluetooth.

4. Select Change Bluetooth Code.

5. Enter a new four-digit code, then select OK.

Ring Tone

There are three different ring tones available for the UHP system.

To change the ring tone:

1. Press the CONFIG button.

2. Select Phone Settings, or touch Phone on a navigation radio.

3. Select Ring Tones.

4. Select Ring Tone 1, 2, or 3.

Default Settings

Selecting this option will reset the ring tones and the Bluetooth code.

    See also:

    Center Console Storage
    Push the button (A) to access the storage or accessory power outlet under the armrest. See Power Outlets  for more information. Some vehicles might also have input jacks for auxiliary devices ...

    Keys
    CAUTION: Leaving children in a vehicle with the ignition key is dangerous for many reasons. They could operate the power windows or other controls or even make the vehicle move. The children or ...

    All-Wheel Drive
    When to Check Lubricant It is not necessary to regularly check fluid unless you suspect there is a leak or you hear an unusual noise. A fluid loss could indicate a problem. Have it inspected and r ...