Hood

To open the hood:

1. Pull the hood release handle with this symbol on it. It is located under the

1. Pull the hood release handle with this symbol on it. It is located under the instrument panel on the driver side of the vehicle.

2. At the front of the vehicle, pull up on the bottom center of the grille, and

2. At the front of the vehicle, pull up on the bottom center of the grille, and push the secondary hood release to the left.
3. After the lid has been partially lifted, a gas strut automatically lifts and holds the hood in the fully open position.

Before closing the hood, be sure all filler caps are on properly.

Pull the hood down to close.

Lower the hood until the lifting pressure of the strut is reduced.

Then allow the hood to fall and latch into place under its own weight.

Check to make sure the hood is closed. If the hood does not fully latch, gently push the hood down at the front and center until it is completely latched.

    See also:

    Adding Coolant
    If you need more coolant, add the proper DEX-COOLВ® coolant mixture at the coolant recovery tank. CAUTION: Turning the radiator pressure cap when the engine and radiator are hot can allow stea ...

    Conference Calling
    Conference calling and three-way calling must be supported on the Bluetooth phone and enabled by the wireless service carrier to work. To start a conference while in a current call: 1. Turn ...

    Reprogramming a Single Universal Remote System Button
    To reprogram any of the three Universal Remote system buttons: 1. Press and hold the desired Universal Remote system button. Do not release the button. 2. The indicator light will begin to ...