Turn and Lane-Change Signals

An arrow on the instrument panel cluster flashes in the direction of the turn

An arrow on the instrument panel cluster flashes in the direction of the turn or lane change.

Move the lever all the way up or down to signal a turn.

Raise or lower the lever until the arrow starts to flash to signal a lane change. Hold it there until the lane change is completed. If the lever is briefly pressed and released, the turn signal flashes three times.

The lever returns to its starting position whenever it is released.

If after signaling a turn or lane change the arrow flashes rapidly or does not come on, a signal bulb might be burned out.

Have the bulbs replaced. If the bulb is not burned out, check the fuse.

See Fuses and Circuit Breakers .

    See also:

    Curve Tips
    Take curves at a reasonable speed. Reduce speed before entering a curve, while the front wheels are straight. Adjust speed so you can drive through the curve. Maintain a reasonable, steady s ...

    Brake Fluid
    The brake master cylinder and, on manual transmission vehicles, the clutch hydraulic system use the same reservoir. See Engine Compartment Overview  for the location of the reservoir. The reser ...

    Braking
    Braking action involves perception time and reaction time. Deciding to push the brake pedal is perception time. Actually doing it is reaction time. Average driver reaction time is about three-fourt ...