Universal Remote System Operation

Using Universal Remote

Press and hold the appropriate Universal Remote button for at least half of a second. The indicator light will come on while the signal is being transmitted.

Erasing Universal Remote Buttons

All programmed buttons should be erased when the vehicle is sold or the lease ends.

To erase all programmed buttons on the Universal Remote device:

1. Press and hold down the two outside buttons until the indicator light begins

1. Press and hold down the two outside buttons until the indicator light begins to flash, after 20 seconds.
2. Release both buttons.

Reprogramming a Single Universal Remote Button

To reprogram any of the three Universal Remote buttons, repeat the programming instructions earlier in this section, beginning with Step 2.

For help or information on the Universal Home Remote System, call the customer assistance phone number under Customer Assistance Offices (U.S. and Canada)  or Customer Assistance Offices (Mexico) .

    See also:

    Headlamps, Front Turn Signal, andParking Lamps
    To replace a bulb, do the following: 1. Open the hood. 2. Remove the grille by grasping and pulling it forward. 3. Lift the two headlamp retaining clips. 4. Pull the headlamp assembly away from ...

    Trunk
    WARNING Exhaust gases can enter the vehicle if it is driven with the liftgate, trunk/hatch open, or with any objects that pass through the seal between the body and the trunk/hatch or liftgate. ...

    Windshield Wiper/Washer
    The windshield wiper lever is located on the left side of the steering column. : Use for a single wiping cycle.   : Delays wiping cycle. : Slow wipes. : Fast wipes. : Turns the wiper ...