Heated and Ventilated Front Seats

If you cannot feel temperature change or pain to the skin, the seat heater mayWARNING
If you cannot feel temperature change or pain to the skin, the seat heater may cause burns even at low temperatures.

To reduce the risk of burns, people with such a condition should use care when using the seat heater, especially for long periods of time. Do not place anything on the seat that insulates against heat, such as a blanket, cushion, cover, or similar item. This may cause the seat heater to overheat.

An overheated seat heater may cause a burn or may damage the seat.

Heated and Cooled Seat Buttons Shown, Heated Seat Buttons Similar

Heated and Cooled Seat Buttons Shown, Heated Seat Buttons Similar

If available, the buttons are on the center console. To operate, the engine must be running.

press to heat the seatback only. (Heated Seatback): If available, press to heat the seatback only.

to cool the entire seat. (Cooled Seat): If available, press to cool the entire seat.

Press to heat the seat and seatback. (Heated Seat and Seatback):

Press to heat the seat and seatback.

Press the button once for the highest setting. With each press of the button, the seat will change to the next lower setting, and then to the off setting. The lights indicate three for the highest setting and one for the lowest.

The passenger heated seat may take longer to heat up.

The heated and/or cooled seats are canceled after the ignition is turned off.

Remote Start Heated Seats

When it is cold outside, the heated seats may turn on automatically during a remote vehicle start.

The heated seats will be canceled when the ignition is turned on.

Press the desired heated seat button to use the heated seats after the vehicle is started.

The heated seat button lights will not turn on during a remote start.

The temperature of an unoccupied seat may be reduced.

See Remote Vehicle Start  for more information.

    See also:

    Using the Dial Command
    1. Press and hold for two seconds. The system responds with “Ready” followed by a tone. 2. Say “Dial”. The system responds with “Dial using <phone name>”. “Number please” ...

    Cleaning the Display
    Notice: Using abrasive cleaners when cleaning glass surfaces could scratch the glass. Use only a soft cloth and do not spray cleaner directly on the system as it could affect the mechanical ...

    Front Fog Lamps
    For vehicles with front fog lamps, the button is located on the outboard side of the instrument panel. The ignition must be on to turn on the fog lamps. (Front Fog Lamps): Press to turn the f ...